Eaton Network Management Card Uživatelský manuál stáhnout pdf (Strana 22)

www.eaton.com

Network

Management Card

(Network-MS)

User Manual

Network Management Card – User Manual 34003991XT_EN/EG Page 22/142

3.1.2 Your network is not equipped with a DHCPv4 server

In the main menu enter 2, then 2 again. The menu is displayed:

Follow the instructions and enter the static IP parameters.

At the end of the menu, wait for the "Done" message to be displayed indicating that the IP parameters have been

saved.

-----------------------------------------------------------------------------

Network settings

-----------------------------------------------------------------------------

1 : Read Network settings

2 : Modify Network settings

3 : Set Ethernet speed

0 : Exit

-----------------------------------------------------------------------------

For each of the following questions, you can press <Return> to select the

value

shown in braces, or you can enter a new value.

Should this target obtain IP settings from the network?[N] N

Static IP address [xxx.xxx.xxx.xxx]? xxx.xxx.xxx.xxx

Static IP address is xxx.xxx.xxx.xxx

Subnet Mask [xxx.xxx.xxx.xxx]? xxx.xxx.xxx.xxx

Subnet Mask is xxx.xxx.xxx.xxx

Gateway IP address [xxx.xxx.xxx.xxx]? xxx.xxx.xxx.xxx

Gateway IP address is xxx.xxx.xxx.xxx

Wait during your new configuration is saved ...

Reset the card to take into account the new configuration.

Return to the main menu and enter 1 then 2.

The card restarts with the new IP parameters.

3.1.3 IPv6 Parameters

The IPv6 parameters are read only through the serial line configuration menu. If IPv6 is enabled, all IPv6

addresses of the card can be read from the HyperTerminal™. The “Your network is equipped with a DHCPv4

server” chapter describes the steps to follow to display this addresses.

3.2 Test after configuration

To check that the Network Management Card is operational after installation and configuration:

 From a station connected to the same subnet as the card, open a web browser and enter the IP address

of the card in the address field

 Check the display of the home page.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 141 142

Žádné komentáře

Eaton Network Management Card Uživatelský manuál Strana 22