Eaton Network Management Card Uživatelský manuál stáhnout pdf (Strana 83)

www.eaton.com

Network

Management Card

(Network-MS)

User Manual

Network Management Card – User Manual 34003991XT_EN/EG Page 83/142

6 TELNET/SSH/CLI interfaces

6.1 Introduction

This chapter describes how to use the Telnet/SSH/CLI interfaces of the IBM Network Management Card.

6.2 Settings list

The parameters accessible via Telnet, SSH or CLI are the same as those offered by WEB interface.

The use of these parameters remains the same. For more explanation about theses parameters, the default

values, possible values, please refer to the previous chapter (§4 - Supervision and administration by browser) of

this document

6.2.1 Network settings

These settings enable the administrator to configure the network parameters of the card and authorisation of the

remote upgrade of the embedded system.

The parameter list is the following:

 MAC address (read only)

 IP address

 Subnet mask

 Gateway address

 Host name

 Domain name

 BOOTP/DHCP

 IPv6

 IPv6 autoConfig

 IPv6 address 1

 IPv6 prefix length

 IPv6 Gateway address

 IPv6 local address (read only)

 IPv6 address 2 (read only)

 Updating software

 Primary DNS server

 Secondary DNS server

 SMTP server

 SMTP port

 SMTP server authentication

 SMTP login

 SMTP password

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 141 142

Žádné komentáře

Eaton Network Management Card Uživatelský manuál Strana 83