Eaton Network Management Card Uživatelský manuál stáhnout pdf (Strana 21)

www.eaton.com

Network

Management Card

(Network-MS)

User Manual

Network Management Card – User Manual 34003991XT_EN/EG Page 21/142

3.1.1 Your network is equipped with a DHCPv4 server

The card is configured by default with this service activated.

The card automatically collects IP parameters.

To know the IP parameters, type 2, the next menu is displayed:

-----------------------------------------------------------------------------

Network settings

-----------------------------------------------------------------------------

1 : Read Network settings

2 : Modify Network settings

3 : Set Ethernet speed

0 : Exit

-----------------------------------------------------------------------------

Then type 1. The menu is displayed:

Network configuration :

MAC address : 00:20:85:FD:1C:07

Mode : Static IP

IP address : xxx.xxx.xxx.xxx

Subnet mask : xxx.xxx.xxx.xxx

Gateway : xxx.xxx.xxx.xxx

Link Local IPv6 address : xxxx::xxxx:xxxx:xxxx:xxxx /xx

Global IPv6 address : xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx /xx

Note the IP address.

The IPv6 parameters are only read only.

To exit, enter 0 then 0. The card is operational.

Note: As long as the card is not connected to the network, it continuously attempts to make connection. Once the

connection has been established, the operational mode presented in the table above becomes effective.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 141 142

Žádné komentáře

Eaton Network Management Card Uživatelský manuál Strana 21