Eaton Network Management Card Uživatelský manuál stáhnout pdf (Strana 61)

www.eaton.com

Network

Management Card

(Network-MS)

User Manual

Network Management Card – User Manual 34003991XT_EN/EG Page 61/142

 Application Name: Given by the application at subscription time.

 Output: number of the UPS output from which the client is powered.

 Configuration: shows where the parameters of the Intelligent Power Protector come from: Local

(coming from the application) or Central (coming from the card).

The Central shutdown configuration is available by clicking on the Configuration link.

 Shutdown duration: the shutdown duration necessary to properly shutdown the computer.

 Shutdown after: the time available to the user from the power failure until the launch of the shutoff

sequence of the UPS and equipment.

 Connected: This value is set to YES if the notified application connects through TCP protocol.

Many actions are available on this page:

 Remove: Depending on the kind of application, the selected ones will definitively disappear from the

table as SNMP applications, or they will disappear and automatically re-subscribe as Intelligent Power

Protector applications.

 Utility failure Test: Two alarms, 'Utility failure' and 'Utility restored' spaced 60 seconds apart, will be sent

to the applications selected, making sure that the applications can be reached over the network.

 Shutdown Test: This test simulates a UPS low battery sequence. It enables an easy check to see if the

server protection works correctly.

- No intervention on the UPS is required.

- The applications selected will process the simultaneous alarms and perform an actual shutdown

sequence.

WARNING!

- This test will generate a REAL shutdown sequence of the selected servers on which the Intelligent Power

Protector application is running.

 Add NMS: allows an SNMP trap receiver to be added such as a Network Management System.

 Modify NMS: allows an SNMP trap receiver to be modified.

Both buttons open a new window where it is possible to enter the Application name, the Hostname or IP

Address, the trap port, the protocol version needed: V1, V3 or both, the Trap community (only used in

V1) and the filter on the several implemented MIBs.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 141 142

Žádné komentáře

Eaton Network Management Card Uživatelský manuál Strana 61