Eaton Network Management Card Uživatelský manuál stáhnout pdf (Strana 75)

www.eaton.com

Network

Management Card

(Network-MS)

User Manual

Network Management Card – User Manual 34003991XT_EN/EG Page 75/142

5 Server protection

5.1 Set-up of the shutdown parameters

The protection application: Intelligent Power Protector, on protected server boot, subscribes itself automatically to

notified applications list and sends its essential data:

 IP Address or hostname of the server on which it is installed: So that the card can inform it of power

events.

 Time required to shutdown the server (Shutdown Duration, configurable in the "Set-up" menu of each

IPP): The card takes into account the longest shutdown time of all the Intelligent Power Protector

subscribed (This is the Shutdown duration of the Shutdown parameters) page to manage UPS

shutdowns without affecting any of IPP connected.

During normal operation, the protection application periodically checks its connection with the card.

In case of a major power event, the card sends information to the protection application which reacts according to

the situation. (shutdown order, programmed actions, messages to the administrator and to users via the network)

When the server shuts down, the protection application unsubscribes itself from the notified applications.

5.1.1 Shutdown criteria managed by the Network Management Card

During an extended power failure, three criteria may cause the server shutdown procedure to be initiated. If

several criteria are selected, (See page Shutdown parameters), the first criterion encountered will launch the

shutdown procedure.

At the end of the shutdown procedure, when all servers have been shut down, the UPS may shut down to avoid

unnecessary discharge of its batteries, depending on its configuration.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 141 142

Žádné komentáře

Eaton Network Management Card Uživatelský manuál Strana 75